noGoods
There are no products in your shopping cart, go and choose a product!
这是描述信息

FAQ

分类:
FAQ
2020-10-30
Q

①. Heating the Nozzle to 240 degrees, click fast extrusion.

②. Heating the Nozzle to 200 degrees, clean it with a Nozzle cleaning needle (hot, pay attention).

③.If that doesn't work- replace the nozzle.

分类:
FAQ
2020-10-30 20:34:30
Q

The nozzle is too far away from the hot bed. Please check if the nozzle is too close or too far away from the hot bed

Select the Brim option under Build Plate Adhesion when attaching object to platform in slicer ,increasing the value of the brim width according to your needs. Set hot bed temperature to 65°. Necessary temperature will vary with type of filament used.

分类:
FAQ
2020-10-30 20:43:39
Q

Remove the leveling sensor, then adjust Z0,install the filament, then preheat the nozzle to 210 ° C,preheat the hot bed to 60 ° C, feed filament and start printing.
Click once to move the nozzle 0.1, Z+ nozzle moves up, Z-head moves downwards, the software automatically saves the value after clicking, and the value is saved until it is leveled again.
 

分类:
FAQ
2020-10-30 20:29:54
分类:
FAQ
2020-10-30
Q

Remove the leveling sensor, then adjust Z0,install the filament, then preheat the nozzle to 210 ° C,preheat the hot bed to 60 ° C, feed filament and start printing.

分类:
FAQ
2020-10-30 20:29:29
上一页
1
Online customer service
Customer service hotline
Service time:
-
Customer service group:
Online Message
Skype:
Message

CONTACT US

Address

ADD :

Room 502 and 503, Building 6, Phase II, No. 27, Fenglin Road, High-tech Industrial Development Zone, Zhengzhou, Henan

 Copyright © Zhengzhou Chaokuo Electronic

Technology Co., Ltd All rights reserved. 

豫ICP备2020034676号
Powered by www.300.cn

Business License 

 Copyright © Zhengzhou Chaokuo Electronic Technology Co., Ltd All rights reserved. 

豫ICP备2020034676号      Powered by www.300.cn

Business License